Photo Frame 18 x 13 cm (7 x 5.1 Inches)

thingiverse

If there problems with "Download All Files"-button download allFiles.zip instead. Photo frame for photos up to 19.5 x 14.9 cm (7.6 x 5.8 inches). 3:2 format. This one came about because I needed a frame and the stores here in Germany are closed on weekends. For Prusa Mini and Prusa Slicer there are Picture_Frame_Front_Prusa_Mini.3mf and Picture_Frame_Back_Prusa_Mini.3mf. Here it is printed diagonally and upright so that it fits on the printing plate. Support and props must be removed afterwards and the surfaces must be reworked. On printers with a print width of 210 mm (8.3 inches) or more, this frame can be printed flat as normal. Support is then not required. A passe-partout can be created from drawing cardboard with a cutter knife. To do this, cut out a 19.5 x 14.9 cm (7.6 x 5.8 inch) rectangle, then measure 3 cm (1.2 inch) from each edge and cut out the inside with the cutter knife. Then place it in front of the photo with the pencil lines to the back so they can't be seen from the front. The back can be screwed with small screws M2x8.