Phycodelic Solar Led Windmill

thingiverse

Windmill with solar led lights that swivel in each blade. This should be fairly easy to print. Designed so no supports are needed. Printed on anet a8 220mm bed but should fit 200mm bed if you rotate the part at a 45 degree angle. : added high res filet edges blade (blade filet 45.stl) either blade works fine but using a brim will help keep it stuck to the bed. Parts to print: 5 - blades 5 - LED holder rings 1 - blade hub 1 - base 1 - tail fin Optional Parts 1- base to pole spacer rebar ( this fits over 1/2" rebar I use for a pole and inside 20mm hole in bottom of base). Note - A 3/4" or 19mm pole will fit with out spacer. Parts to buy: 2 - 608 bearings (skate board bearings) 1 - 5/16 or 8mm bolt, 2-nuts, and 3-washers, 5" or 125mm length (for hub shaft) 1 - pole to mount on. 1/2" rebar I had laying around or 3/4", 19mm dowel or? 5 - LED stake lights (55 or 56 mm, or a little less then 2 1/4" diameter. height 27 or 28 mm, a little less the 1 1/8"). Heres an amazon link to LED light but I get mine at Family Dollar store for $1 each. https://www.amazon.com/dp/B07D3RJ4MN/ref=psdc_14193171_t3_B07DHJ7DV9