Pi Butter Bot

prusaprinters

<p>This is a remix of the Butter Robot Xiaofang by Simomura, and also uses</p> <p>the Rick and Morty Butter Bot Wyze Adapter by Capt Obvious.</p> <p>I expanded the Base to fit a Raspberry Pi 3 or 4 and added a spot for a 30mm fan in the top.</p> <p>The Tracks are in TPU and are used to keep the base together. I scaled them down 5% to fit tightly and ensure the two halves stayed together.</p> <p>The Head Base part that fits in the the Wyze Adapter needs to be scaled down about 5% as well as I created the original too large. I used some extra filament in the hole provided to secure the head lift arm to the base.</p> <p>So far the head will not stay lifted as is and I plan to work on improvements or take suggestions to fix it if anyone has any.</p> <p>The Picam fits inside the head but I've had troulble keeping the front on without gluing it so scaling it down 2-3% might work to fit it tightly and keep it in place.</p> <p>The Cable ports use scrap filament, and could be scaled up about 5% or so to fit.</p> <p>This is currently a work under renovation as I continue to improve it so questions and suggestions are welcome.</p> <p>Print the Base Top with the flat side down. Did not require much support other than the arms as in the original.</p> <p>I use the arms and bust portion without change from the original.</p> <p>Created/Modified it all in TinkerCad.</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Creality</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>Ender 3</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Resolution:</strong></p> <p>0.2</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>15</p></div> <p><strong>Filament:</strong> Generic PLA &amp; Eryone TPU PLA &amp; TPU Gray, White, Black</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>Tracks can be printed in PLA, but sizing might be an issue.<br/> Only support needed are for the Arms as in the original Butter Robot. </p></div></p></p></p> Category: Electronics