Picatinny scope mount for 1 inch receivers

prusaprinters

<p>A friend of mine bought a savage 23 which was drilled and tapped for some obscure or possibly homemade mount, this is a simple mount that uses the holes on the side of the receiver to mount and allows use of standard picatinny rings. I have left the side plate blank so you can drill your own holes for your specific use case. Recommended to print from carbon fiber petg or similar material for maximum rigidity with 4 walls and 30% honeycomb or gyroid infill at 0.2mm layer height or smaller. I've attached a screenshot of the recommended orientation to print it in, your bed leveling and z offset needs to be spot on but this will give you optimal surface finish and accurate, straight sides as well as good strength along layers.&nbsp;</p>