Picture Maker with waste filament

thingiverse

The issue with 3d printing is you usually have offcuts of filament. This is a solution to allow you to turn those offcuts into art. How to make a picture: ------------------------------- Each hole on the picture make board is 1.85mm in diameter so is suitable for 1.75mm filament 1) print one of the picture maker boards 2) place it over a picture 3) Use small offcuts of filament to make the pattern by inserting them into each hole then cutting off the excess filament. Keep doing this step until all holes are filled To lock the picture in place: ------------------------------------ 1) Preheat an oven to 200degree centigrade 2) Place put the picture maker board in the oven 3) Wait for the pasting to soften i.e. about 5 minutes. You can normally tell is ready as it will become shiny 4) Finally remove the picture from the oven and leave it to cool. If you would like to see the process I made a video which is on tiktok video link: https://www.tiktok.com/@themadrobot/video/7060591104378359046?is_from_webapp=1&sender_device=pc&web_id7007511511506994694