PiDP-11 Case extension and feet

thingiverse

This is an extension to the case of the PiDP-11 kit found here: https://obsolescence.wixsite.com/obsolescence/pidp-11 The existing case is not really deep enough to allow you to use the suggested panel mount port extensions off the raspberry pi (unless you hack the cables up pretty badly). Instead, I've extended the back of the case and replaced the wooden stand with built in foot pads/legs. For the legs, I've included only 1 model. Simply print 1 as is, and then a second as a mirrored image. I used a small nut and bolt to link the 2 halves of the box together. 3" long screws were used to replace the original 1" ones found in the kit. You'll need to drill holes for the screws to go through in the case as I didn't add those to the model.