Pine A64 Two-Parts case

thingiverse

WARNING Cases with fan support have been removed, the position was wrong and didn't match the CPU. I will add them again later. So this is basically the Pine Brick Case without the sliding element. Easier to print, easy to mount. Parts needed to close the case: 4xM3 screws, 29mm long 4xM3 nuts Print with supports touching buildplate. Files description: bottom.stl: The bottom of the case top.stl: The top of the case, with no additional holes (as shown in the pictures) top_buttons.stl: The top of the case, with holes for power/reset buttons top_GPIO_EULER.stl: The top of the case, with holes for GPIO and EULER bus top_buttons_GPIO_EULER.stl: The top of the case, with holes for power/reset buttons, GPIO and EULER bus top_30x30fan.stl: The top of the case, with holes for a 30x30mm fan. top_30x30fan_buttons.stl: The top of the case, with holes for a 30x30mm fan and power/reset buttons. top_30x30fan_buttons_GPIO_EULER.stl: The top of the case, with holes for a 30x30mm fan, power/reset buttons, GPIO and EULER bus. top_30x30fan_GPIO_EULER.stl: The top of the case, with holes for a 30x30mm fan, GPIO and EULER bus. top_40x40fan.stl: The top of the case, with holes for a 40x40mm fan. top_40x40fan_buttons.stl: The top of the case, with holes for a 40x40mm fan and power/reset buttons. top_40x40fan_buttons_GPIO_EULER.stl: The top of the case, with holes for a 40x40mm fan, power/reset buttons, GPIO and EULER bus. top_40x40fan_GPIO_EULER.stl: The top of the case, with holes for a 40x40mm fan, GPIO and EULER bus. Enjoy! Print Settings Printer: Wanhao Duplicator i3 Rafts: No Supports: Yes Resolution: 0.2 Infill: 30% Notes: Supports touching buildplate