Pineapple Springo (Half Size)
myminifactory
Pineapple springo? Say no more... This is the half-scale version of my Pineapple Springo, part of the Tasty Springos Pack No.1 which you can check out here. I got the best results printing with 3 outlines/shells, 0.15mm layer height, and enough solid top & bottom layers to make the spring part solid infill. No supports required. After printing, carefully separate the coil using a thin spatula, palette knife, butter knife, etc. Work slowly and with caution, especially if you are using sharp tools! *note:* These Springos can be very large and complicated models. Slow computers may struggle with the springo part. There may also be tiny 'holes' that can prompt errors or warnings, but I have sliced these files without issues using Simplify3D and Cura. Results may vary with other slicers. Please share your experiences good and bad so I can continue to improve. Thanks ☺︎ Springos pictured were printed using MatterHackers PRO PLA (Clear, Blonde, Green) and Fillamentum Vertigo Galaxy PLA
With this file you will be able to print Pineapple Springo (Half Size) with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Pineapple Springo (Half Size).