Ping Pong Ball Dispenser

thingiverse

This is a Ping Pong Ball Dispenser that works by sliding the "dropperkey" into to small rectangular slit on the "droppertube". There should be a small rectangular hole that lines up with the peg on the "dropperkey". You connect "droppertube2" to "droppertube" by lining up the slanted portion on the top of both prints and using the guiding bars found on "droppertube2". Simply insert 5 ping pong balls in the back of "droppertube2", and press the key down into the ground, and lift the entire object back up. If slanted, a ping pong ball will fall out. This design was used for the Northrup Grumman 2019 Design Challenge. In our case, the Dispenser was attached to a drone, hence the slanted portion on top of the prints. Thanks for looking at my design, and make sure to leave a comment if you have any questions.