Pipe Holder

thingiverse

This pipe holder is meant to hold 1/2" standard PVC, as well as to have the bottom sit in the opening of the same-sized pipe. There is a little wiggle room on both the top and the bottom radius. It was useful for my design to be able to swivel slightly for minor adjustments. The I.D. of the labeled 1/2" PVC pipe is in actuality around 15 mm, so I have the bottom radius set to 14.5 mm, resulting in a 0.25 mm annulus of air between pipe and holder when centered. A few wraps of thread tape should do the trick if you need to keep yours for rotating. My application is static and only slightly load-bearing, so the wiggle-room is desired.