Piper 2 - BLTouch and E3D Mount (yet another)

thingiverse

This is a brand new BLTouch mount for the Piper 2 X-Carriage. Based on ANTLABS documents, this positions the BLTouch sensor (or clone) as close to the heat block as recommended (15mm), and at a fixed z-height from tip of hot end to bottom of BLTouch translucent body (8mm). This mount should work for BLTouch "Classic v1.0" through "Smart v3.0". This offers several features and benefits: BLTouch mount, E3D hot end mount, 6-32 nut retainer for lower belt tensioner (I can modify model for metric nuts if requested), unobstructed viewing of print head/nozzle, and maximum bed probing area due to close proximity to print nozzle. Print vertically, with supports only needed in E3D mount area and the lower BLTouch mount area as the images show. Firmware Offsets: x_offset: 28.5 y_offset: 0 Installation: Insert two 6-32 nuts into the mount (for belt tension), insert two M3 nuts into the mount (for BLTouch), insert E3D hot end into the mount, install mount and E3D to X-Carriage, install BLTouch using M3 SHCS to mount, install lower X-Carriage belt and tension. BLTouch documentation: https://www.antclabs.com/manual