Pipette Stand

thingiverse

I took the overall design of the Pipette Stand from user janh. I increased the height of the sides of the stand so that they would be long enough to accommodate my pipettes. I simplified the shape of the top support to decrease the number of different parts needed for the build (as is visible in the picture of the completed build, this did not impact the item's usefulness). Depending on print settings, there might be an issue with the tolerance between the horizontal rest parts fitting in their holes in the vertical side parts. Mine were a tight fit, and the tolerance was 0.5 mm. This tolerance might need to be increased for other printers (either by decreasing the cross-sectional area of the supports or increasing the area of the voids in the sides).