Pipolino - Cat feeder

thingiverse

My cat was getting a bit fat, so i decided to design this pipolino feeder for her. It is easy to print, i used supports only for the cap part, but might not be needed. The inside part can be inserted two different ways so you can have 2 or 4 holes for the food to drop. The same cap is used at both ends, but the bottom cap should be fixed to the outside part, either by inserting 4 pieces of filament trough the small holes, or simply add a few drops of glue. You can also add rubberbands or any kind of gasket to the caps for reduced noise. Let me know what you think :)