PLA ABS Fan Duct for e3d V6 MP Select Mini

thingiverse

So I loved the PLA ABS fan shroud from xenomorphdelombre as I could easily switch ABS and PLA with the divider but there wasn't anything like it for my e3d v6 so I had to make one. I do have the official e3d v6 so I'm not sure about this working with clones, might, might not, I don't have one to test with. (Just a note, the block in the picture is not the e3d block as I broke the nozzle in mine, but since then I've got a replacement and installed it and it's fine.) Just a note on the screw holes: I'm using stainless steel m3 hex screws that are 20mm I believe, but you can use whatever you want. You just need to widen the holes of course with a drill or even a few twists of an hobby knife will do. (I'm using the stainless hex screws because I've replaced most all visible screws with them to match.) I'm also working on a dual 40mm fan version as well, look for that eventually. I have the MP Select Mini V1, not sure if it will work with the V2 but I don't see why not