Planer Board System

thingiverse

UPDATE 6.14 (print in progress)- I have made another box-style system specifically for the "Walleye Board" by Church Tackle. If you are just looking for a side mount style, just check the files. Although the only difference would be the slot in the back. Board Hole Size 110X22. There is a slot that is offset to allow the clip and hardware to drop through. You will need to check to make sure this will fit your board. Metal Size is 16G Steel (Menards) Bottom 178x230x1.8 <---- This is the size of the hole I would suggest being 1-2mm smaller on each side. Below are the directions for my first attempt at this. Unfortunately, it never made it to my printer as I realized the dimensions were too small for the board I was using. If you print it PLEASE post a pic and a comment. Click here for a full explanation ---> https://youtu.be/R2tzjPLt1ak End Boards are only for the box configuration. There are notches at the ends so they fit into the others. Side Boards are able to be mounted on their own. That is why they have the front holes. Metal Size is 16G Steel (Menards) 168mmX238mmX1.8mm <---- This is the size of the hole I would suggest being 2mm smaller on each side. I realize that I don't really need both side and end boards posted but I did this just in case I made an alignment mistake with the screw holes. Last note I have not yet printed so this is experimental. If you decide to print please let me know how it went.