Plant information label holder

thingiverse

Spring is here and planting of flowers and other forms of life is beginning. Have designed it by request of my wife. Can also be used for self introduction! :):):):) (see the last picture!) One sign is 1.5 mm thick (the label plate). It looks in proportion and is firm enough for use. Another is 3 mm thick (again this is thickness of the label plate) and is extra firm. Both take approximately same time to print an use very similar amount of filament. I have printed it in white PLA. 0.25mm layer height, 2 shells, 4 top and 3 bottom solid fill layers, 20% infill. News! now wife-approved - got an order to manufacture 30 pieces :) Let your flowers bloom and gardens grow! Enjoy! :) Print Settings Printer: Raise 3D Plus Rafts: No Supports: No Resolution: 0.25 mm Infill: 20 Notes: 2 shells 4 top and 3 bottom 100% solid fill layers 20% infill Post-Printing Writings can be done this way: On the most flat side (the one which rested on the print-bed) apply transparent sticky tape and use a permanent marker to write the information. Writing on the printed surface directly might blur along print lines.