Plaque for Metallica Wall mount

thingiverse

This is a plaque for http://www.thingiverse.com/thing:154990 I printed both in ABS and used Acetone to glue them together and get a nice finish. I think this size was for the hands while printed at 140% scale. There are three ingresses on the rear so that it can be hooked onto a nail or screw on a wall, I only needed the middle one for mine but included all three just in case there was an in-balance of weight once I had glued the hands on. No Support required Instructions Make sure your build plate is very level. If printing in ABS, allow to cool to room temperature before removing or else it will warp.