Plaster Cast Pot for 100mm inner Pot

prusaprinters

<p>A mold (negative) for a plaster pot.<br><br>You need to print five of the sideparts and one each of the inner and the top part.<br>Atleast the big inner part needs a good sanding and maybe mold seperator, i used normal olive oil and it worked just fine; else it will be really hard to seperate the part from the pot.<br><br>Prints without supports, needs just little infill but probably 3-5 shells.<br>Uses 3 big (or more smaller) cable ties, like shown in the pictures attached.<br><br>If you use a water absorbing material like i did (plaster) you should use a inner pot (or a coating), so the plaster doesn't get wet. I used a Geli 10cm pot with a matching coaster which fit perfectly. <a href="https://www.idealo.de/preisvergleich/OffersOfProduct/6010766_-blumentopf-10cm-weiss-geli-thermo-plastics.html">https://www.idealo.de/preisvergleich/OffersOfProduct/6010766_-blumentopf-10cm-weiss-geli-thermo-plastics.html</a><br><br>Pictures with a plant inside will follow.</p>