plastic rivet for Toyota Venza

thingiverse

This one fits the 9.8mm hole for the plastic plug that holds the plastic cover piece near my battery. The original broke as it was removed (as they usually do). [I had to removed the cover to remove the bolt that held my battery in place in order to change the battery] - It took me 40min to print 2 of them. - Final size= 23.3mm long with a 2mm thick head (24.2mm diameter). (These measurements are close to that of the original plug I removed) The picture shows the broken one and the two printed ones and where it goes in and after it has been placed. Openscad program should be fairly easy to change parameters to fit end requirements. I did see others that were similar but I think that this one is closer to the one that was broken.