Plus Minus Button Thermomix TM31

cults3d

This model arises from the need to repair the buttons of the Thermomix, without disassembling it. This model takes several hours of design and a lot of trial and error, until I finally got a working model. On one side is the button that can be glued to the console of the machine with a glue that is not too strong, in order to prevent dirt from entering and in turn keep it fixed. Any dirt from its predecessor must be cleaned off before applying the glue as it fits a little tight. On the other hand there is the extension that will push the button and must be attached to the button before installing it on the machine, in this case a stronger SuperGlub type glue can be used. I hope you get a good result!