PM-1000 Featherboard

prusaprinters

<p>Featherboard and miter slot clamp for a Powermatic PM-1000 table saw.</p> <p>The featherboard is designed to go right up to the blade so you can do fairly thin rips on the saw.</p> <p>Uses 1/4"-20 nuts and bolts. Glue the top and bottom spindle parts together with a nut in the proper place. Place a bolt through the miter stop and put it in the miter slot. Place the featherboard over the bolt and tighten in place.</p> <p>Should work on a PM-2000 if the miter slot dimensions are the same.</p> <h3>Print instructions</h3><p>Print is set for 0.30 mm draft, 20% infill, with Prusament PLA. Supports on for overhangs for the bolt head/nuts.</p> <p>This gives a decent strength/flexability trade-off for the fingers.</p>