pololu Current Sensor Mounts.

thingiverse

This mount will allow upright mounting of the Pololu ASC711EX (tested with the -15 - +15amp as well as the -30 - +30 amp versions.) This will hold the asc711ex current sensor carrier upright without pinching the board. It basically floats but is held in place by the pins and bolts holding your wires. No stress on any of your solder joints. Access to both sides of the current in/out wire (screws and nuts) and no need to install standoffs or other detailed or difficult installs (upright saves space on your builds as well!) Instructions Printed with .25mm height, so it has room to move, but cannot be removed from mount. place pin end of the sensor board up through the base, screw the base to the mounting surface using 3mm screws. then attach/remove your high amp current/volt wires as needed. Simple to change polarity without uninstalling the mount!