Popper Fishing Lure

cults3d

This is small Popper type fishing lure. The lure is printed in two halves and then glued together. There are two different version each with slightly different popper faces (everything else is the same). Hardware Required to Assemble (3) Alignment Pins (made from 1.75mm filament) (3) #6 Figure 8 Hook Hangers (Available from https://lurecomponents.worthco.com) (2) .177 BB's I used #6 Treble Hooks w/ #3 Split Rings Tools Required to Assemble Razor Blade/Knife Drill and Bits (1.8mm or a 5/32") Lighter CA Glue (superglue) CA Accelerator Sand Paper Paint Epoxy (to seal everything up) IF there are any problems with the STL's or you have questions please let me know. NOTICE - My files and designs are all Copyrighted © and are exclusively for private and personal use. Even if you purchased these files that Copyright means you are NOT allowed to sell the model or any derivative of the model for economic or financial gain. For example, you cannot sell the digital model, a derivative or adaptation of that model, nor can you sell prints of the model. I do however grant permission for persons who purchase any soft bait molds to sell the rubber soft baits you make with one of my printed soft bait molds.... but again you CAN NOT sell the actual models of the baits.