Porsche Panamera 970 Samsung Galaxy S22 Ultra (w/ Standing Protective Cover) Mount

thingiverse

(This is a modification of my [previous ROG Phone 2/3](https://www.thingiverse.com/thing:4380978) holder that works with a Samsung S22 Ultra w/ case) Introduction ========= There's STILL no attractive and functional phone holder for the Porsche Panamera (especially if you don't want to use adhesives and trip clips). It's a niche project, but works exceptionally well... and who needs an ashtray anyway?! This is compatible with 2010 - 2016 Panamera models (970.1 and 970.2) and is designed for the Samsung Galaxy S22 Ultra with [Protective Case](https://www.samsung.com/us/mobile/mobile-accessories/phones/galaxy-s22-ultra-protective-standing-cover-navy-ef-rs908cnegus). The holder BASE and WEDGE should be printed in TPU or FLEX and are simply inserted into the ashtray. No clips, no adhesive, no modifications to your car. The TinkerCAD is [maintained here](https://www.tinkercad.com/things/iMOmwgcuNRO-panamera-970-phone-mount-for-s22-ultra). Printing Instructions: ================ * Print the WEDGE in TPU or FLEX. I used clear TPU from SAINSMART. Printing with a .10mm layer thickness works well. Print bottom-down (normal orientation). No supports are needed. * Print the BASE in TPU or FLEX. I used the same SAINSMART TPU. I recommend printing at a relatively large layer height. Either .20 or .30mm leaves nice ridges on the sides that seem to grip the ashtray nicely. Print top-down (slot facing down) and you won't need any supports. * Print the ARM in something heat appropriate. PLA definitely gets flexy in hot climates. I used ABS for the latest version, but PETG works too (keep in mind tolerances and material shrinkage if you use ABS and PETG, scale up by .2-.5% if necessary). Print upside down with supports, with the mounting face on the print bed. No supports necessary. Layer height is at your discretion. Thicker layers print faster and have a different aesthetic. I printed my parts at .20mm. * Print the BODY in the same kind of material as the ARM using the same settings, but WITH supports. Scale up by .2-.5% if necessary due to cooling shinkage. Print normal orientation (back on the print bed)... I experimented printing vertically, but had some warping because it took longer. YMMV. Assembly Instructions: ================= * You will need (4) 10-32 x ~1/4 or 3/8 long screws and nuts with a shallow head to attach the body to the arm. * Insert the WEDGE between the ashtray and console opening just above the release point (see ashtray photo above). This prevents accidental ejection of the ashtray as well as firms up the mounting for the holder. * Position the ARM below the body and align the holes. The ARM should "point" towards the side of the phone without volume or power buttons (See photos for reference.) * Use the 4 10-32 screws the BODY to the ARM. You may need to use a screwdriver as the tolerance is very tight. Tighten the 4 nuts _reasonably_ onto the screws. I found that skipping washers worked well with 1/4" screws. Don't over-tighten anything. * Insert the ARM of the assembly into the slot in the BASE. Note the orientation of the BASE relative to the ashtray. * Gently insert the BASE fully into the ashtray. Removal Instructions: ================= * Gently lift the BODY/ARM/BASE assembly straight out of the ashtray. * Remove the stabilizing WEDGE from between the ashtray and the console opening.