Portable Chewing Gum Case

thingiverse

Intro The goal of this project was to make a gum case to prevent the crushing of gum in transit. The gum case also needed to be one handed. I have been using this personally for around 3 months but have now just gotten around to releasing it. What you see is my third attempt at the case. Other designs have been tried, but this one seems to fit the gum without being too loose or too tight, and the lid friction seems good. Parts List Body Lid Hardware (all available from McMaster-Carr): 1 x M3 Nuts (http://www.mcmaster.com/#90685A037) 1 x M3 20mm Screw (http://www.mcmaster.com/#91290A123) Read assembly instructions for more details. Use Use to hold up to 5 pieces of gum on each side. Hold in primary hand with fingers wrapping around body. Put on lid, and case should open to allow gum to be dispensed. Use thumb to push gum up. Change List v1: Initial release Instructions Print both parts at 20% infil, 1 or 2 shells. Print oriented so the open part of the case is towards the sky. Nut goes between the spaces for gum. Simply put on the lid and screw down the 20mm M3 screw.