POTP Optimus Primes neck adapters - Separate Orion Pax - Power of

cults3d

So I finally got the Power of The Primes Optimus Prime released in 2017. I avoided it back then because of how it looked in Vehicle mode and the fact that Orion Pax had to be plugged in to make Optimus Prime. Well now that I found it cheap, I kinda dig it. However I still wanted two separate bots, I took it upon myself to make it so. This is the most simple solution to do it that I could think of and it's easy to print. Print two with one being mirrored, You will have to remove the three screws that hold Orion Pax together to separate Prime's' chest piece. Pop Prime's head and neck out from Orion Pax's body. Place the chest piece into Prime's body. Put the adapters on the neck pegs and poke the head onto the body. If the holes are too tight, drill them out.