Power Button Housing

thingiverse

LED Power Button Housing made to mount to 3d printers for relocating power button or for accessories. One version has rails to slide into the extruded rail slots and holes for Tnuts in the back to prevent it from sliding when pushing the button. 2nd version has holes for Tnuts only so that you can mount it without having to take anything off the printer in order to mount it. To install the button in the housing drop the threaded washer in the slot with flat edges on the sides & one of the points facing down, thread the socket wires through the hole in the back and push the socket down out of the way. Screw the button in through the threaded washer all the way. Check the orientation of the power symbol if it matters to you & then push the socket onto the button's pins until the latch clicks into place. It is a tight fit to get the socket to click into place you will have to push on it after lining up the pins. You may have to unscrew the button and rotate it before threading it back in in order to get the power symbol facing the direction you want because the current design will not allow the socket to rotate all the way around. Don't break the pins trying to spin the button around after the socket is in place. Here are the buttons I designed this for. https://www.amazon.com/dp/B071H9KXKQ/ https://www.amazon.com/dp/B07JH9DKLQ/ 03/05 edit - Added 2 files with shorter housings, one with original 19.5mm hole & one with slightly larger 19.9mm hole. 3/10 edit - Added new housing without a slot for the washer, raised the housing up away from the base to give additional clearance and enlarged the interior opening to use less material, untested but printing right now. Edit to add this is now the best one, much easier to use