Power supply housing with voltage converters

thingiverse

This supply housing will take the standard 120 volt AC to 12/24 volts . It features two step down converters and switches, also note it uses a three prong cord adapter I salvaged from an old computer power supply. The fixture appears to be pretty common, but check your measurements to be sure it will fit. The cutouts for the step down converters are also an item I would check to be sure they fit your units, the ones I had were not the same as the thing I used to create mine. Finally, please keep in mind this was put together with Tinkercad and it is everything the program could handle. With multiple crashes and reloads it is bound to be a little off. I printed both halves as well as the reset button, and they all fit together with out any real problems. The cut out for the power cord requires clean up to make things fit, this may be an error in the drawing, feel free to fit it if this is the case. I just did a little razor work. Thanks, hope it works for you too.... UPDATE... I assembled the two halves.. it went together okay... still needs some minor adjustments to prevent needing sanding and minor trimming... I am just done with it...and the fact remains, you will have to make some changes to fit your components anyway... feel free to update and clean up... thanks