Power Supply Mount Case Hypercube modified V1.3

thingiverse

I made some changes to the original file so it can use a different power plug and switch, which was sent to me by mistake from Geeetech and I had laying around. 02/25/17 Update #1: I printed a test panel (Image1.jpg) and it looks like a good fit. 02/26/17 Update #2: Printed the prototype, but it didn't quite fit on my power supply due to not enough room for wires inside. So now I'm testing V1.2. Made more room length-wise when upright by adjusting and elongating power supply screw holes. Will print and test soon. 02/27/17 Update #3: Version 1.2 works great. Fits well on the power supply, and there is plenty of room for wires inside. The only downside is that the access hole to adjust the voltage is now at an angle view. I modified the hole position in V1.3, but I will keep printed V1.2 as it took a lot of plastic and is good enough for me. 04/03/17 On special request, I created a "side" version of the switch and power inlet. It's V1.4, enjoy! Thanks to Tech2C for all their work and sharing! Print Settings: Printer: Geeetech Prusa I3 modded Rafts: No Supports: No Resolution: 0.20 Infill: 40% grid