pp3dp Up! PCB Poker

thingiverse

Small tool to poke out the ABS plastic from the PCB platform used by the pp3dp Up! printer. www.madox.net Instructions 1)Print, 0.2mm Layers, Fine, 40 degree supports. Density settings as desired. 2)Extract a pin from a PCB header. Using long nose pliers to squeeze between the short end of the pin and the black plastic works well. (I used side cutters as pliers in an act of desperation) 3)Insert the pin into the 3D printed tool. Hold the pin vertically on a hard surface (that you don't mind damaging) and slowly push down the tool onto the pin. Careful not to bend the pin. 4)Use to poke out ABS stuck in those annoying holes ;) www.madox.net