Predator fan duct and led ring V2

thingiverse

After a few month of use of my previous design, I've rebuild this new one Two downsides on the previous design linked ot the fact the led ring was very low : - it was hiding the nozzle - the PLA was bending over the time (probably because it was close to the heat bed and probably too thin) This new one is a mix of the original predator fan duc and a led ring, all in one piece. The led ring support is thicker than in the previous model It is made in a way the led ring will glow nicely by transparency accross the PLA. I've used this hardware : led ring (80mm 12V) : https://www.aliexpress.com/item/Hot-2Pcs-Bright-White-80mm-Angel-Eyes-24-SMD-LED-Ring-Car-Light-C45/32828959363.html?spm=a2g0s.9042311.0.0.4dc64c4daw8dWU DC Buck Step Down Power Converter Module (drop 24V to 12V) : https://www.aliexpress.com/item/LM2596-Buck-Step-down-Power-Converter-Module-DC-4-0-40-to-1-3-37V-LED/32641300009.html?spm=a2g0s.9042311.0.0.4dc64c4daw8dWU I suggest also to add a switch ... no need to have the led enabled all night !