Print-rite Y-axis blocks - Bearing Cover - Colido DIY

thingiverse

My first design / model add-on upload. Now two add-ons. 1. One is for the uploaded Print-rite Y-axis block model ONLY. https://www.thingiverse.com/thing:1654491 ( By: shawdreamer ) 2. The other baring cover is for the original factory Y-axis block. 3. I've also remixed the right block as the belt pulley bracket was a little too narrow. Also added some screw holes and remodeled some of the weight saving holes, to allow the screws to have better bite. This cover is a quick fix. Print two of them and clip them in and screw into side of Y Axis End Block. Use 3mm drill as required and 4 to 5mm screws. Not yet tested in anger, but will in due course. Just getting this out early. Use at your own judgement call and only if required. NOTE1: Might offer an alternate version design with additional screw points. NOTE2: Supports are built into this model, so turn supports OFF when printing this model. Feel free to Let me know how you go. Raft optional depending on your print surface. Good Luck