Printable Arduino UNO Clip-in Holder

thingiverse

I liked Darthwahl's version but wanted the extra post. Also, my board fit REALLY tight inside the clips - enough to cause the bottom to warp. I adjusted the clips a little and added a post. Once I consider a few mounting options, I plan to either add screw blocks or holes for mounting. Instructions I printed with a little extra fill and 1 extra shell. My blue ABS oozed a little so some trimming by razor blade was necessary. I'm still learning but the scaffolding/support under the tabs was less than perfect so those had to be cleaned as well. Note: Be very careful if you insert your board and decide to remove. The posts will break off easily. I guess you can always print another one!