Printable Magnet 1/4" Bit Screwdriver With Storage

thingiverse

This is a screwdriver that accepts 1/4" screwdriver bits. You must pause the print right under the beginning of the chamfer at the top of the internal cavity underneath the bit socket, and then install two or three 5/16" diameter x 1/8" tall rare earth magnets with super glue. I used magnets from Harbor Freight. https://www.harborfreight.com/10-piece-rare-earth-magnets-67488.html It has a screw cap to hold bits inside it. The bits will be loose without a magnet unless you narrow the hexagonal socket by a few tenths of a mm!