Printable S-Hook

thingiverse

This is a printable S-Hook. It is very similar to "http://www.thingiverse.com/thing:7769" except you define the inside radius of the hook openings. Instructions Printing is very simple. Just lay the S Hook flat on the platform and it should build without any problems. These are the parameters you can adjust: top_hook_radius: [Mili Meters] This is the inner radius of the top S Hooktop_hook_radius = 33.5; bottom_hook_radius: [Mili Meters] This is the inner radius of the bottom S Hookbottom_hook_radius = 7.7; width: [mili meters] This is the size of the S Hook body (in X&Y directions)width = 10.0; thickness: [Milli Meters] This is the thickness of the S Hook (in Z direction)thickness = 60.0; start_angle: [DEGREES] This adjusts where the opening in the S Hook startsstart_angle = -10; end_angle: [DEGREES] This adjusts where the opening of the S Hook ends. Normally end_angle will be ~-90 degrees. This is so the transition from top to bottom hook is smooth. If you want the opening to be somewhere else than adjust this value.end_angle = -89;