Printed - 3D Puzzle Eagle

thingiverse

This is a Remix of the LaserCut - 3D Puzzle Eagle located here: http://www.thingiverse.com/thing:30990 (All credit for this design goes to jtronics) I really wanted to print this, so I took the .dxf file provided by jtronics (see link above) and imported it into Blender 3d and added depth. It took a bit of tinkering to find the right thickness. I found that 1.35mm fit together perfect for my printer. If it doesn't for you, you'll probably have to adjust the thickness manually like I did. Another good thing about 1.35mm is that I can print at .27mm layer height and get exactly 5 layers. Also, I printed at 100% infill Instructions Default thickness for the plates is 1.35mm so I print at .27mm to get exactly 5 layers at 100% infill. I have only printed this in ABS thus far. Scaling it down to 75% worked fine as well. Your mileage might vary depending on your printer. A good test would be to print two of the smaller objects and see how they fit together before printing the whole thing. Print one of each plate: Base1_Plate.stl Base2_Plate.stl Body_Plate.stl Feathers&Misc_Plate.stl Wings_Plate.stl I have included the individual files incase your build plate isn't as large as the Replicator 2x and can't use the plates. You will have to print the quanity listed below: Half_Ring_Tab - 2 Connector - 4 Large_Ring - 1 Base - 1 Half_Ring - 2 Small_Ring - 2 Ring_Connector - 2 Head - 2 Body - 2 Wing_Connector - 2 Foot - 2 Back_Large - 3 Back_Medium - 1 Back_Small - 1 Head_Connector - 1 Back - 1 Feather1 - 2 Feather2 - 8 Feather3 - 2 Feather4 - 2 Feather5 - 4 Feather6 - 2 Feather7 - 2 Feather8 - 4 Feather9 - 2 Wing - 2 Tail - 1