PRINTNC - Modified Z Motor Mount - Endstop Sensor Hole Larger and Reinforced

thingiverse

This is a modified Z motor mount for a PRINTNC. This is based off of: https://www.thingiverse.com/thing:5210851 I initially printed the original model, but the hole wasn't large enough to pass my sensor through. I drilled out the hole, and it left the mount weak down the centerline on the front face. I just added some geometry to help reinforce the 12.05mm hole, and give it a flat surface to tighten a nut to on the top of the sensor, if needed. On my machine, I had less than 8mm of room from the back of the spindle to the front of the Z mount. This mount is less than that. Let me know what you think. As with everything, this is a prototype model and you print at your own risk. This works on my machine, but your results may vary. I am adding the f3d model as well, but it's just the original STL imported in, and modified. R3X