Printrboard bracket for Mendel Prusa V2

thingiverse

Yet another pcb holder, this time for a Printrboard on a Mendel Prusa V2 I am building. Not only does it secure the pcb safely against the side of the printer it also has cable tie holes to secure a tidy loom. The idea is to mount the pcb upside down with the USB port to the rear, the plug should fit between the cross member. It also puts the power inlet low in the back right corner. I usually run my printer to the left of my computer so it is designed to go in the back right corner of the printer but it wouldn't take much to mirror image it for the back left position. My apologies for the crude mock up pcb - I will update the pictures when my Printrboard arrives in the next few weeks. Instructions Print it out - I used 3 layers of PLA, 2 perimeters, 25% infill and 45 degree fill angle. All the holes and nut recesses came out correct on my printer with no need to drill out. The frame clips onto the diagonal and lower side threaded rods and doesn't really need to be secured but the machine screw holes are there so you may as well use them. The holes to the left of the board are for cable ties to secure your loom in an orderly fashion.