Printrbot 1405 Filament Guide and Cleaner

thingiverse

Pictures pending! It's my first upload, but it's a filament guide and cleaner. Took about 30 minutes to print on the stock Printrbot 1405. It connects on your Z axis bars. The long notched end goes at that back, feed the filament through the first eyelet, fold a small piece of paper towel or put a sponge into the arch, pass the filament through it out the front of the arch and into the second eyelet. Put a little piece of painters tape on the bottom half of the back of the arch to keep the paper towel in. Move the filament back and forth make sure it's not getting caught anywhere and not pulling the towel/sponge out the front or the back of the arch, then feed it into the extruder. That's all. Instructions I've been playing around with TinkerCad.