Printrbot Simple Wide Foot Print Foot Pegs

thingiverse

The original feet for https://www.thingiverse.com/thing:593072 were too big to insert in the bracket, because I did not have flexible filament. Originals probably fit snug, when printed with different filament. Someone mentioned https://www.thingiverse.com/thing:280489 these scaled at 130%, however they were too big. Bottoms are 1"; I tried to use felt pads, but they slide to much. So I created these and made them from stock PLA, they are 3/4" or 20mm & they fit perfect & snapped into place. I added some rubber pads from Home Depot, and the now the printer does not shift around or move, and it is quietier. Shout out to Thorped for the design on the foot bar, it is very durable and the best I have seen yet. Snaps into place and widens the stance. Highly recommend you print it, try all of the pegs and find what works best for you. *** Update... I did remix the the pegs and created a small void for a .5" pad, this is the one I have been using on 3 Simple Metals for the past 6 months. You can buy sticky rubber .5" pads for a few dollars at Home Depot. They work better because the rubber pad stays in place. I printed them with a 15% support (easier to remove). The pad fits snug, which is good and makes it to where the machine is not only quiet but doesn't vibrate on the table.