Pro DnD Case V7 Split

thingiverse

This is a quick remix of Berko's DnD Case V7 split using this SPL splitter: https://htmlpreview.github.io/?https://raw.githubusercontent.com/arpruss/stlutils/master/split.html# Thanks to Alexander Pruss http://www.thingiverse.com/arpruss/ for the simple JS tool See the original at https://www.thingiverse.com/thing:3500077 There are no other changes but the single file made it nearly impossible to print. I hope you find it helpful. Instructions from the original: Amount of Plastic used: 75 - 80% of a 1KG roll of PLA (including support material) Nozzle: 0.4mm @ 195C Layer Height: 0.2mm Bed: 60C - for the larger prints, A thin layer UHU glue stick helps! Speed: 50-55mm/s Infill: 15% - if you go lower in %, (eg 10%) you will need to increase top layers to 5 to remove Bumps. on the slide lid, 100% infill is best! Walls: Top 4 to 5 - Depending on your infill! above 20% around 3-4 is fine! Walls; Bottom - 2 to 3 layers. Walls: Sides - i used 2 on mine.... Ive had no issues for 3 weeks now! 3 would be ok, 4 is wasting time printing and plastic. Material: PLA is fine. ABS if your more daring! lol You will need 20 1X3mm Magnets for this build - Cheap of Ebay! As with Berko I will restate: - - - NOTE: THIS IS A COPYRIGHT FREE DESIGN!!! - - - MEANING: YOU CAN MAKE, MODIFY AND SELL WITHOUT INFRINGEMENT!!!