Propel Endeavor Davega X Mount

grabcad

Intro: This is a Davega X eskate telemetry module mount for the Propel Endeavor Pro/S.READ THIS:There are 2 versions of the base plate, one sloped at 25 degrees (MOD 2 V2) and one sloped at 15 degrees (MOD 2). The 25 degree slope base will bring the unit parallel to the deck while the 15 degree slope base will give you a 5~10 degree angle relative to the deck. Choose one based on your height and ride style.Additional parts required:1. Davega X Eskate telemetry module (https://shop.davega.eu/)2. Davega X Rubber Gasket (https://shop.davega.eu/)3. Possibly need long 5x M2.5 or M3 screws and matching nuts to secure the Davega if mounting plate holes are too large to be screwed into. I would buy these just to be certain the mount doesn't come loose from vibrations.4. glue depending on quality of printInstallation:1. Remove all 4 screws securing the front metal plate that says "Endeavor".2. place the base where the metal plate was and secure the screws.3. secure assembled Davega X to mounting plate with gasket in between. The flat side of the plate should be facing up with the arrrow on the bottom pointing towards the front of the board. The wires should be sandwiched between the gasket and Davega X and sticking out the mount towards the back of the board.4. use force and slide the mount onto the base plate. Should the fit be a bit tight, I found the hammer method very effective. 5. Should the fit be too loose, there is a slot for an M3 nut in the base that will lock the mount to the base. To install this, first mount the base to the board, put the nut into the slot, slide the base plate over the mount, screw an M3 screw through the hole into the mount and into the nut in the base, and install the Davega. Glue also helps.