Protek 35 Analog to Digital DJI antenna mount

thingiverse

A simple antenna mount I made for converting an analog Protek 35 to use a DJI air unit with TBS crossfire. I printed in TPU with 100% infill not that there is much on this print. I used Prusa slicer and put a support enforcer under the slat at the back that holds the nano receiver. The dome area with the SMA pigtail holes prints fine without supports and prevents excess mess. My print was much more flexible than the stock analog mount. Not sure if this is down to the TPU I am using or if the design could do with being thickened up