Prusa I2 frame lift

thingiverse

I kept running into the problem that I didnt have enough room under the prusa i2 to put the electronics and power supply, so I just built these. Just print 4, print the adjustable feet found here, 4 of them also and replace those with the feet vertexes that you usually have on your printer with these ones here: http://www.thingiverse.com/thing:108841. I used 4 6 inch pieces of 5/16 threaded rod from the vertexes to the feet pieces, then just cut the other pieces to size after putting everything together. I didnt use any washers on the bottom row because they go past the bottom of the feet. Ive been using this for a little while, and I havnt had an trouble with any wobble, the frame is very sturdy, and you dont have to worry about the thing tipping either way while printing either. I just stuck on these rubber feet that you stick on to each of the feet, and they everything is rock solid while everything is running.