Prusa i3 Steel Sheet Holder

thingiverse

Prusa i3 spare steel sheet holder. These are 2 separate parts, left and right. I put mine under my Ikea Lack table, but just about any bottom of a table or desk will do. This is only meant to be mounted under something and mounted flat, not to the side (vertically). This is tall enough to fit about 7 sheets and even more depending on the thickness of the tape if not screwed in. SCALE TO 1000% WHEN SLICING To install: I found it difficult to mount to the bottom of my table with screws so there are a few options. The easiest would be to use 4 command strips or mounting tape and press it on while upside-down. The parts do have 2 holes each for wood screws, but it may be difficult to hold the parts and screw. You can always flip the table over and attach it that way. Put the sheet between the holders and then mount to make sure it fits properly. It also helps to have the sheet overhang the edge of the table a little to make for easier access and visibility when placing. Parts needed: 1 Left holder 1 Right holder 4 5x20mm wood screws OR 4 command strips / mounting tape (Command strips can be any size, I used the smallest size and has a strong bond to my lack table.)