Prusa LACK enclosure gap fillers

prusaprinters

<p>Credits to cisardom for thing<br/> <a href="https://www.thingiverse.com/thing:2864118">https://www.thingiverse.com/thing:2864118</a></p> <p>and Mikolas Zuza for the guide<br/> <a href="https://blog.prusaprinters.org/cheap-simple-3d-printer-enclosure/">https://blog.prusaprinters.org/cheap-simple-3d-printer-enclosure/</a></p> <p>I was a bit unhappy with the final build because cutting the plexi to 440 x 440mm left a gap between the LACK and plexi of aprox 5mm along each leg/vertical edge of the plexi. Due to the design of the plexi holders there will also be a 2mm gap on the horizontal edges.</p> <p>So I made some simple gap fillers that fit quite nicely on my build. The STL files are for 3mm plexi cut to 440x440mm.</p> <p>I attached a parametric 3ds file where you can adjust for plexi thickness and plexi length to some small degree.<br/> NB - it will not change the length of the rails as they are static to the measures of the IKEA LACK. Adjusting L - length will simly make the groove deeper or shallower. Therefore you can only set values between 440mm and 432mm.</p> <p>I also had to use a 1,5mm spacer in betweed the legs and bottom parts to make everything fit properly.</p> <p>What to print:<br/> You'll need two of each vertical fillers and four horizontal for each of the three sides. Havent made any for the door yet.</p> <h3>Print instructions</h3><h3>Category: 3D Printing Print Settings</h3> <p><strong>Printer Brand:</strong> Prusa</p> <p><strong>Printer:</strong> I3 MK3S</p> <p><strong>Rafts:</strong> Doesn't Matter</p> <p><strong>Supports:</strong> No</p> <p><strong>Infill:</strong> 15%</p>