Prusa MK3 Filament Guide Remix

thingiverse

This is a Remix of TechnoSapienDesign MK3 Filament Guide. I think its a great addition to the Prusa but I was curious to see how it would perform with an oval opening as apposed to a circle opening. This guide prints in two pieces and then snaps together. I found the guide works great when you are using a new spool of filament. It helps keep the filament from going over the edge of the spool and getting tangled. I would use caution when printing tall prints with the glide. Since the top is removable you could decide when to use the guide and when to remove the top part. Share a picture if you make one!