Prusa mmu 2.0 wall mount

thingiverse

BEFORE PRINTING FLIP 90 DEGREES TO FLAT SIDE!! This is a wall mount for your filaments with a Multi material Upgrade for prusa printers but really it could be used without it too. here are two holes to feed your filament out through the bottom for saving space, they have a 3 mm diameter so they can work with both filament sizes, if it doesn't fit, obviously you should drill it out or carve it. To fasten the top and bottom i used m3X.5 screws and m3 nuts. M3 SCREW SET: https://www.amazon.com/Stainless-Assortment-Precise-Beautiful-Printed/dp/B0714FLXND/ref=sr_1_2_sspa?ie=UTF8&qid=1548298098&sr=8-2-spons&keywords=m3+assorted+screws&psc=1 For the bearings on the sides and 608b skateboard bearings will work and an 8x120mm rod to fit across, if you need to just print one, 8mm diameter 120mm height. I used a .6 nozzle for speed and strength, pla works fine since its not really under any stress and it has supports on it. To mount it just use any screw and drill through the hole. Message me for any questions this is my first publish ;)