PrusaBox Enclosure - Buck Converter box with WAGO holders, RJ45 Network Port, Enlarged Rocker Switch Opening

prusaprinters

<p>Note: Please see my remix &nbsp;<a href="https://www.prusaprinters.org/prints/155787-prusabox-enclosure-enlarged-buck-converter-box-wit">https://www.prusaprinters.org/prints/155787-prusabox-enclosure-enlarged-buck-converter-box-wit</a> for an enlarged version of this same design to more easily fit all the wires with the relay in the lid.</p><p>This is a customized version of the PrusaBox Buck Converter box. &nbsp;Things that were customized are:</p><ol><li>The opening for the rocker switch was enlarged as I couldn't easily get the size that was in the original design. &nbsp;I enlarged the opening to 19 mm x 12.6 mm. I'm in Canada, so the switch I used is on Amazon at <a href="https://www.amazon.ca/gp/product/B07Y1GDRQG">https://www.amazon.ca/gp/product/B07Y1GDRQG</a></li><li>Added a modular coupler for a RJ45 network plug. &nbsp;Here is the coupler I used. I think these are fairly standard size so hopefully other brands would work. &nbsp;The coupler is inserted with the clip on top. <a href="https://www.memoryexpress.com/Products/MX41753">https://www.memoryexpress.com/Products/MX41753</a></li><li>Added holders for WAGO connectors to clean up the wiring, and make attaching wiring more easily. &nbsp;There are two 5-conductor connectors, and one 3-conductor connector. &nbsp;The main positive and negative 12V wires from the buck converter feed into the back of the custom holder and up to the top. &nbsp;The positive connects to one of the WAGO connectors, and the negative connects to another connector. <strong>Note</strong> that I do not want to take credit for this WAGO holder design. &nbsp;I found a version of this holder on Thingiverse at <a href="https://www.thingiverse.com/thing:4635919">https://www.thingiverse.com/thing:4635919</a> and want to give credit to Thullen. &nbsp;I just modified this design to add another 3-conductor at the end, and make modifications so I could mount it in the buck converter box, and added a hole at the back to allow the power leads to feed from the back rather than through the bottom.</li><li>Made a wire access hole at the end of the buck converter box to more easily feed the USB cable to Raspberry PI, and the network cable.</li></ol>