Push Fight!

thingiverse

Based on http://www.pushfightgame.com/ . You can buy a wooden version of this (with box and instructions!) here https://store.penny-arcade.com/collections/media/products/push-fight . (note that this benefits me in no way, only the creator and distributor of the game, I'm just a fan) Instructions on how to play can be found at both links. I think I added a basic improvement over the available model by allowing the anchor to actually sink into the square piece and the gameboard below. If contacted by the creator Brettco, Inc. I will take this down. Note this is listed as NON-COMMERCIAL. Do not profit from this unless you are Brettco, Inc! (And if you do, let me know!) Printing directions You will need to print "PF_Pieices" twice. I recommend using a different color filament for each: set 1, set 2, and gameboard/anchor. Please note that you should increase the scale of this! I suggest 2x to get close to a normal game piece size. The smaller the part the less likely they'll fit together well and will also be very hard to move individually. "What is this, a game for ants??" The Anchor will fit in the holes and lock into the board (a little loose, but still). With the new "diamond" shape at the top hopefully now it won't require as much support structure. (my initial anchor was just a pyramid on a pole, but required some supports) I'd suggest a neutral or gameboard matching color for the anchor piece since it is a shared piece, but have left it separate from the gameboard so that you can choose do color it differently. Infill: I suggest you do a minimal fill since these are just shapes pieces. Material, etc etc is up to you. I used basic 1.75mm PLA at .4. Why did I design this? I needed something basic to practice modeling with and had enjoyed the look and play of this game. My thought was that having a pocket/cheap travel version would be great!